LMS-forum
 
Post Reply
Who Can Post? All users can post new topics and all users can reply.
Username   Need to register?
Password:   Forgot password?
Subject: (optional)
Icon:  
Formatting Mode:
Normal
Advanced
Help

Insert Bold text Insert Italicised text Insert Underlined text Insert Centered text Insert a Hyperlink Insert E-mail Hyperlink Insert an Image Insert Code Formatted text Insert Quoted text Insert List
Message:
HTML is On
Smilies are On
BB Code is On
[img] Code is On
;)roll ;) :upset: :toilet:
:puke: :m16: :laugh: :holy
:finger: :D :cry: :cool:
:comp: :comp1: :coke: :car:
:bounc: :) :(

Disable Smilies?
Use signature?
Turn BBCode off?
Receive email on reply?
Attachment:
    

Topic Review
willem

 posted on 14-3-2005 at 11:26
As this article was written for far more biger engines then the bison I reckon you need to adjust the values a bit.
First recommendation:
2 minutes on 3 volts frontwards and backwards
1 minute in a new clean cup frontwards and backwards.

I already blew one engine away for Moers. Had to use Tamar's group c engine:):):)

Experience will tell in the end:):):):)
2h

 posted on 14-3-2005 at 10:23
Does this mean that a Bison motor should run for 18-20V i 3 minutes in the first bucket of water, then first 1 minute in the other, then rest 1 minute, then run 1 minute again. The altasista translatie van Nederland to English is not the world best :)

Off to buy some distilled water.....:car:
willem

 posted on 14-3-2005 at 09:53
http://members.lycos.nl/franshop/tip24.htm
Go To Top