Post Reply
Who Can Post?
All users can post new topics and all users can reply.
Username
Need to register?
Password:
Forgot password?
Subject:
(optional)
Icon:
Formatting Mode:
Normal
Advanced
Help
Andale Mono
Arial
Arial Black
Book Antiqua
Century Gothic
Comic Sans MS
Courier New
Georgia
Impact
Tahoma
Times New Roman
Trebuchet MS
Script MT Bold
Stencil
Verdana
Lucida Console
-2
-1
1
2
3
4
5
6
White
Black
Red
Yellow
Pink
Green
Orange
Purple
Blue
Beige
Brown
Teal
Navy
Maroon
LimeGreen
Message:
HTML is On
Smilies are On
BB Code
is On
[img] Code is On
[quote][i]Originally posted by Massiven[/i] Hey there, well at the Worlds last year we used the SLP-Chassis with the 44 theeth gear, but note that you can't use the original axel holders. You'll have to buy other axel holders from Plafit. They have 4 different kinds. Then you can use the photoetched spacerplates to do fine tuning on the setup an you can reach the 1mm clearance without getting problems. I raced the 27,5mm wheels but I had 1,1mm clearance at the front and 1,3mm clearance at the back. Little remark: you have to use higher axel holders in order to decrease the clearance! same principle for front and back. you're right that chassis was developped for the bison motor that is used in the 3 SLP series: SLP, SLP Challenge and SLP Cup. but for the so called "lady-shave" motors you can already get the motor holder including the counter-holder. Don't think it will fit the Proslot-Motor! cheers, mike [/quote]
Disable Smilies?
Use signature?
Turn BBCode off?
Receive email on reply?
Attachment:
Topic Review
This is a long topic, click
here
to review it.
»
Tech tips
»
ProSlot motor mounting on Plafit
» Reply